Use of pneumatic diaphragm pumps

  1. Test the pump

After the new pneumatic diaphragm pump is connected to the air source, the air supply pressure needs to be slow from small to large, and it is necessary to pay attention to the micro diaphragm pump. The empty time cannot be too long, the air pressure cannot be too large, and the ball valve can be avoided.

  1. Install and use

The pneumatic diaphragm pump is installed on a flat table, the foot is fixed, and the inlet and outlet pipes and air source can be connected.

  1. Use precautions

The air source of the air pump should be pure, and it is necessary to avoid hard substances such as sand and dust entering the air valve, otherwise the air valve will be easy to wear, and it is recommended to use a pressure regulator filter to control the air source. Then the inlet pipe must ensure that the seal is intact, otherwise there will be air entering and resulting in the suction of the feed.

Pneumatic diaphragm pumps do not need to add any lubricant before and during use. However, when it is necessary to reassemble after disassembly, an appropriate amount of grease can be added between the center shaft and the sleeve, and a layer of grease can be applied to the inside of the outer pressure plate during the installation of the diaphragm pressure plate, which can be convenient for positioning and easy to seal and disassemble.

saiken Pumps is a manufacturer and supplier of pneumatic diaphragm pumps

Use of pneumatic diaphragm pumps-China Saiken Pumps